Our review:

Item Description:
This triple IR mouse emitter features small infrared LEDs that mount over the IR window of any electronic component. It is terminated with a mini plug for simple installation with any IR emitter block. 8 ft. cord with a 3.5mm plug. Flasher measures: 7/8' L x 1/2' W x 5/8' H. Specifications: *Power: 120mW *Invert Voltage :5V *Continual current: 80mA *Wave length: 940nm *Transmission distance: up to 12 ft.



Check out these accessories for this item:
  click for more

Check out these accessories for this item:

• Buffalo IR-100 IR Receiver
• Buffalo DV9-500 9VDC 500mA Power Supply for IR Receiver

---

Some related products we found for you:
     click for more

Some related products we found for you:

• Next Generation Remote Control Extender
• NGHP LRRX-2 AAA-TX (Extra RF Transmitter For 433.92 MHz)
• NGHP 2/3 Rechargeable Battery For RF Transmitters
• Logitech Harmony 550 Universal Remote
• Buffalo DV9-500 9VDC 500mA Power Supply for IR Receiver
• click for more

---

Buyer's review: - Works well
These work as they say the only problem I have is that they occasionally fall off because they are not stick enough to stay on. that's my only gripe.

---

Buyer's review: - Perfect solution for IR extension
I have a home theater I've been building for a number of years and when I painted the walls and ceiling dark colors my IR universal remote could no longer bounce the signal off the front wall and screen to hit the equipment in a rack behind me. I did quite a bit of research and for the money found the Buffalo Electronics IR solution was what I needed.

Initially I thought I'd have to buy two control blocks in order to have enough flashers for all my devices and then I found this item that has three emitters instead of just one or two like the others that I had found. They installed without any problems and work perfectly. Easy to use (plug and play really) and work great.

The only thing I might point out is that they use a thin piece of double sided tape (already on the emitter) to connect to your device. Most of the time this is not a problem but one of my devices had a concave face where the IR receiver was located and the emitter wouldn't stick properly. I was able to make it work with some clear thicker double sided tape (it came in small squares on a sheet).

If you need more emitters and don't want to buy more controller blocks, this is the way to go.